Hi Everyone:
I'm now wiring up the bottom panels to the keelson. Port side looks great. But there's almost a 1/4" gap at the spot where the starboard panel meets the forward most point of the keelson. Is a 1/4" gap acceptable or do I need to remedy? If remedy, suggestions greatly appreciated.
Fair well,
Jimmy Vitale
Victory II
PocketShip.net
For sailors and boatbuilders interested in PocketShip
Bottom Panel to Keelson Gap
Moderator: John C. Harris
Forum rules
Spam or commercial posts will be deleted.
This is a civil forum: no flames or drunken tirades.
Please stay on-topic.
PocketShip's Web Page: http://www.clcboats.com/pocketship
If you need CLC customer service: http://www.clcboats.com/forms/contact_us.html
We'll try to delete spam as soon as it appears.
Spam or commercial posts will be deleted.
This is a civil forum: no flames or drunken tirades.
Please stay on-topic.
PocketShip's Web Page: http://www.clcboats.com/pocketship
If you need CLC customer service: http://www.clcboats.com/forms/contact_us.html
We'll try to delete spam as soon as it appears.
2 posts • Page 1 of 1
Bottom Panel to Keelson Gap
by jwv630 on Thu Sep 27, 2012 7:15 pm
- jwv630
- Posts: 141
- Joined: Sun Nov 22, 2009 4:12 pm
Re: Bottom Panel to Keelson Gap
by chaertl on Fri Sep 28, 2012 5:10 am
I had a gap in the same spot and just filled it. As long as it's completely filled when the cloth goes over it on both sides it shouldn't cause any problems. When you get to joining the top panels to the bottom above that area be ready with some good clamps though since that's the toughest joint to get closed up in the whole hull.
Chris
Chris
- chaertl
- Posts: 133
- Joined: Sun Jun 13, 2010 8:40 pm
- Location: Minnesota
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 123 guests