Sandpiper was launched a couple of weeks ago, and CLC has posted some launching images on their Facebook page. Here's a short report on the second shakedown sail here in Sydney, Australia (get out your atlases for place names):
Took Sandpiper out in Pittwater yesterday with Peter, our neighbor (who sails regularly on a 30' racer), and a guy from Dee Why who is planning to build a Pocketship. One of those funny days, overcast, wind in bunches, with steady 15 kts, and gusts over 20. With three experienced sailors, we gave it a bit of a workout, and it performed just great. You just can't overpower such a small boat, so we used the new jiffy reefing (slab reefing) very soon after sailing, and with someone playing the main, it was possible to work our way up Pittwater into a gusty NE wind. I had put a Windex on the masthead, and with the arms set at 55 degrees, it pointed just about there, which is what the designer says it will do. It does sail really well on a beam reach, just quietly gets along at about 4-6 kts. It's very dry, only a few splashs in the face over the few hours, and none in the forward cockpit. Nothing broke, thank goodness. I had readjusted the internal balast more forward, and added 20kg, which seems just about right, particularly if the third crew stands in the companionway while tending the jib. The boat tracks beautifully on a reach or downwind, no doubt due to the partial full keel. It also jibes with no fuss or drama.
Problems? The main one is the time to rig and unrig, (see my post on the removeable/foldable tabernacle) as there are 6 main control riggings, all of which have to be threaded through at least 2 blocks, and in some cases 4 blocks before raising the mast. It took about an hour from road rig to ready to launch, and including the washing down, about 2 1/2 hours at home to derig and stow the mast, boom, and bowsprit before dropping the tabernacle and boom gallows to get the boat into the garage. Wish I had a secure place to park it with it in road ready state (which takes 40 minutes from pulling it out of the garage). Works out at about 2 hours for every hour sailing! I have an idea, however, which is to make some temporary "chocks" that sit on the cabin top, and across the posts for the removable boom gallows, on to which I can put the mast and boom/gaff/main, fully rigged to the mast and boat. This setup can fit into the garage. Lifting up the mast and hingeing it, and putting the boom on the gooseneck only take minutes so it will be road ready quickly, and the mast should be able to be raised almost immediately we get to the launch site. I'll work on this after Christmas.
The other problem is the tiller, which is long for good reasons as you need some leverage on a very effective rudder. However, you can't lift it very much due to the size of the hole in the transom, and when the helmsman tacks, he has to cross in front of the tiller, which means anyone sitting aft of the mainsheet block is in the way. I'm thinking of coming up with a tiller with a hinge inside the transom (a strong one!) so it can be lifted to allow the helmsman to slide straight across the cockpit. Other than those, I see nothing I'd like to change on Sandpiper, and it's really performing as advertised. Singlehanding it in our coastal climate of big afternoon (summer) sea breezes will probably take a better sailor than me, and the thought of launching/recovering it on my own is a bit daunting. That said, when we were launching, a South African guy was launching his English Westerley, which is about a 6m open boat in plywood, by himself, and when asked what he was doing, he casually replied he was sailing it down to Sydney Harbour, about 20km of open sea! By the way, I added a transom step, which is a single "U"-shaped step on the back of the transom on the side away from the outboard, so to get out of the water, you pull yourself up by it, put your left foot on the wing of the rudder, reach up for the transom combing, put your right foot on the step, and climb over the transom. On the subject of outboard, the bargain 2.5 hp Vortex (Chinese 2-stroke) is still in its run-in phase, but 1/3 throttle pushes Sandpiper along at about 4 knots, and I'm sure once I can use more throttle it should be able to push against a bit of wind and sea.
Cheers/Merry Christmas
Bob in Sydney