Moderator: John C. Harris
decurtis wrote:Here are some photos of the EZ Loader trailer that I modified. It had a slight drop axle but still not enough for Pocketship to fit in a standard garage. I bought a portable garage with a tall door to store my Pocketship at the cottage. When it is assembled I will post pictures on my blog. The third photo shows the keel trough I made from pressure treated lumber. You can also see that I added taller brackets to raise the height of the bunks. There is also a roller attached at the rear of the keel trough. The cost of the trailer was approximately $1500. All my boat information is at the cottage so I will post the model number of the trailer at a later date.
slash2 wrote:Thanks-that helps. I need to go back and take a closer look. It was pouring down rain when I saw it. I’d have to lower the bunks as the P15 has a keel, but that’s easy. It looks they dropped the trough as low as possible, again because of the keel, so it’s all in my favor.
Could you make a quick horizontal measure from the axle to most forward part of the bow ( or stern). Then I can figure out the rest of the measurements.
Users browsing this forum: No registered users and 256 guests