by DanaDCole on Mon Feb 02, 2015 2:09 pm
Has anyone else had this happen? One of the footwell side panels in my kit is not properly cut. It is the correct length and is of the proper width at the aft end, but about two inches forward of that it dips down about 1/2" or so. It then tapers back toward the proper width until it gets to the forward end, but is still almost 1/16" too narrow at that point. I corrected for the error with the placement of the cleat, but I just don't see how this is possible on only one panel given the kits are CNC cut. It has to have happened to other kits. I hope the rest of this kit is OK.