Keel Pivot Pin Holes
Posted: Fri Mar 20, 2015 7:13 pm
The keel pivot hole in the center board has been drilled oversized and filled with epoxy as per instructions. I did not see in the instructions where the holes that the pivot pin goes through at the keel should be done the same. I am thinking that they should be. Wish I had done it early on it it is needed.
Just looking for advise if I need to do this.
Here are a couple of pictures to clarify what I am talking about.
Close up of the hole in question.
The boat has been flipped a week now. I called in favors to six friends. We had a great time and are looking forward to another "flip party" very soon. I had a lot of beer cans to pickup around the shop the next morning but it was well worth it. It is great to have friends. I was able to pay back two of them by helping the twins with their J-29 mast the next day. Boat people are great people.
Just looking for advise if I need to do this.
Here are a couple of pictures to clarify what I am talking about.
Close up of the hole in question.
The boat has been flipped a week now. I called in favors to six friends. We had a great time and are looking forward to another "flip party" very soon. I had a lot of beer cans to pickup around the shop the next morning but it was well worth it. It is great to have friends. I was able to pay back two of them by helping the twins with their J-29 mast the next day. Boat people are great people.