Spars - chamfering and rounding edges
Posted: Sun Aug 21, 2016 9:55 am
Hi all,
I have been working on the spars and rudder and have some questions about the chamfers and rounding.
I know Dana asked this question before - what chamfering bit did you use on the rudder? I assume the same bit would be used for the chamfers on the bowsprit?
On the tabernacle - how much did you round off the edges?
Thanks,
I have been working on the spars and rudder and have some questions about the chamfers and rounding.
I know Dana asked this question before - what chamfering bit did you use on the rudder? I assume the same bit would be used for the chamfers on the bowsprit?
On the tabernacle - how much did you round off the edges?
Thanks,