Question:
So.....the marks with the x in between them are the right ones. The 2 dashes closest are the ones according to the plans. They are off by about an inch. this is for the starboard side. The port side as you can see in the lowest picture is off about 1/2 inch. I am making sure the boards run parallel to each other.
The distance along the pine strip from the corner across the transom on one side is 21 inches and the other 20 inches. I am hoping this will not cause problems later. I did earlier dry fit the seats and they fit pretty well.
You can check this on my blog with the pictures......
cliffordscull.blogspot.com
So the question is: I recall the side panels when they pulled in to met the transom when i glued it up did not meet perfectly the same on each side. The transom sticks up a little higher above the side panel on one side then on the other. Maybe this is causing the problem discussed above. Is this difference of 21 and 20 inches discussed above a problem?