I put my full weight (190 lbs) on the cockpit deck near the rear cabin wall over the center cleat and the forward 6 inches of it sprang loose with a loud crack.. I managed to pull it back up with a couple of stainless steel screws that I left in and then ran a filet along both sides of the cleat under the deck. Hope this holds. The joint between the rear cabin wall and the cockpit deck held but I have been a little doubtful about this joint from the start, even with a large filet, so I am going to add another strip of 4 inch tape, feather it out and then double lap the glass from the rear cabin wall and the cockpit deck over it. Would hate to have this joint separate after finishing the boat. Just a word of caution to those yet to get to this place in their build.
Herb