by craig on Sun Dec 04, 2016 4:35 pm
The base of the tabernacle shouldn't move,* so there isn't any abrasion or other damage that would occur with it. Make sure it's sealed with epoxy, as you do with all the other wood on the boat. I rounded the corners so it would fit securely into the fillet along the bulkhead 2/anchor well floor junction. I also have the two drainage holes in the sides of the tabernacle so water will drain out. Since there isn't a tight seal between the tabernacle and the floor, water should be able to seep out anyway even without the drainage hole.
*If your tabernacle is moving, get out of the way quickly.
Titania, launched January 2015