by Wayne G on Tue Apr 24, 2018 1:52 pm
Ron,
I keep the boat under a Sunbrella tarp as I am very wary of the intense Florida sun; the topside paint has held up really well and still looks sharp. I followed the builders manual and used Interlux primer under the Interlux Brightside paint. The problem is that water will eventually get under polyurethane paint causing it to blister, I just didn't realize that it doesn't need to be prolonged immersion before this happens. BTW, I really like the Brightside paint as it goes on easily and has a beautiful rich finish.
I contacted Interlux and they advised using VC Performance Epoxy, a two part epoxy coating (its not called paint once you get into two part stuff), but for this to bond the hull surface must be down to the substrate with no remnants of old paint or primer, so while it would be relatively straight forward to apply to an unpainted hull, it would be a complete pain trying to sand my PS 100% back to the fiberglass/resin layer without any old primer remnants. For this reason I don't think I'll go with this option.
Another option would be Pettit Hydracoat Eco, which doesn't contain the usual copper compounds found in ablative paints. It is described as self polishing where it slowly wears away, one microscopic layer at a time, thus preventing slime or other biological buildup. While this is not completely non polluting as the paint will eventually transfer from the hull to the lake it is a lot less toxic than standard ablative paints. The advantages to this paint is that it is relatively hard so does not need annual repainting, it does not lose its anti-fouling properties when the boat is on a trailer for long periods and as the paint polishes away the hull does not need major prep when applying a new coat.
As I'm a couple of months away from repainting the hull I think I'll try a submersion test on some plywood painted with regular oil based gloss house paint. If this can hold up to water immersion for a couple of months without flaking or blistering it would be my preferred choice as it would be hard, durable and permanent (and cheap).
I'm hoping to hear opinions or experiences from others on this forum.
Wayne Gray
Orlando Florida