Hello All,
I decided to start with interior fiberglass work at the bow where no one will see it after foamed in and sealed up. But after multiple attempts at fitting fiberglass to that area (template with paper, tape up, cut and fit here and there...) I just pulled it all out due to the fiberglass pulling away as I work one area or another and then going back with either a brush or roller to get it down only to fail again in another area.
I am back at it now with nothing but a coat of clear epoxy where the glass once covered here and there and it will soon be setup so I don't want to touch it anymore right now. I am wondering if I can just go to the layered approach and lay down small, overlapping pieces maybe every hour or so until it is covered. I am not as flexible as years past and can only just reach the bottom at the bulkhead with a brush tip so it has been rough going.
Anyone with good tips to get this job done? I don't think the other areas would be as tough as this area but I still want to get it done first with all the messing up, etc. before proceeding with other sections.