hull paint overlap at waterline

Welcome to PocketShip.net! This bulletin board is for builders of the Chesapeake Light Craft-John C. Harris "PocketShip" design, a 15-foot micro cruiser sailboat built from a kit or plans.

For more information on PocketShip, click here: http://www.clcboats.com/pocketship

This site gathers PocketShip builders in one place. Here you can share photos, tips, questions, and---eventually---your sailing adventures in PocketShip! CLC will also post design updates and tips here as they come up.

We'll try to knock down spam as quickly as possible.

Moderator: John C. Harris

Forum rules
Spam or commercial posts will be deleted.
This is a civil forum: no flames or drunken tirades.
Please stay on-topic.
PocketShip's Web Page: http://www.clcboats.com/pocketship
If you need CLC customer service: http://www.clcboats.com/forms/contact_us.html
We'll try to delete spam as soon as it appears.

hull paint overlap at waterline

Postby MattaOTS on Mon Aug 17, 2020 11:54 am

I'm painting my hull using black Trilux 33 below the waterline and pre-kote primer along with Brightsides fire red above the waterline. Since the antifouling is darker than the above the waterline paint, the black trilux should go on top of the red when masking to create the line between the 2 colors, right? Is it OK to extend the pre-kote and brightsides below the waterline then paint over that with the black trilux to create the line in the colors, or is another technique needed? The pre-kote and brightsides cans say they are for above waterline use. If they get covered in the trilux will there be any problems?
MattaOTS
 
Posts: 2
Joined: Mon Jun 19, 2017 8:31 am

Re: hull paint overlap at waterline

Postby riverron on Tue Aug 18, 2020 7:58 pm

As long as you are not leaving the boat in the water for long times, John Harris has stated that the Brightside is fine below water line.

I painted below the waterline with Interlux 33 white. No pre-coats.
Above the waterline, I used PreKote Gray and then Dark Blue Brightside.
I then added the White Brightside stripe.

I am not sure about the Black Trilux over the Red Brightside or mixing types of paint.
I think I would get a small can of Black Brightside to do the stripe over the Red Brightside.

You can check with CLCBoats or Jamestown Distributors. The may be able to offer some more information or advice.

Thanks
riverron
 
Posts: 245
Joined: Fri Aug 07, 2015 10:29 am
Location: Richmond Virginia


Return to PocketShip Forum

Who is online

Users browsing this forum: No registered users and 4 guests