Hey everybody,
I am currently working on a partially completed pocketship kit I purchased in December 2021. The boat is completed to approximately pg 129 in the manual and I have discovered a crucial step that the previous builder(s)-I am the third owner- seemed to have missed - the drilling out of the center board pennant hole while the cb trunk is still open/accessible. I did not notice this at the time of purchase, but after reading and studying the manual a number of times (mostly on the steps ahead) have I found that this hole is not in place. Any suggestions/procedures as to how to drill/fill/drill this hole without fouling the inside of the cb trunk with squeeze out?
thanks in advance,
Todd