OK, I have the bottom and sides attached, got #4 floor to align with keel, sides, bottom skins and cradle. Now trying to get the cradle to align with everything at bulkhead 7 and off by about 3/4". Trying to figure out how to get it all to align and just don't see how with proper dimensions for the cradle parts. How critical is it to have the aft cradle component attached to #7, the floor and sides? Can I just forget worrying about the cradle on the aft end and get on with it?
Anyone else have problems with this effort? I have measured 3 times but not sure it's worth worrying about. Otherwise I will maybe remove the 2 cradle connecting members and shorten 3/4 inch before trying again.
All suggestions welcome.
Mike