A two part question:
1. I'm starting to stitch in the topsides and everything seems to align pretty well except for where it hits the rear cabin wall (see picture). The profile of the cabin wall doesn't match up to the side-topside junction. The topside would have to do some serious bending to conform. I assume the thing to do is cut a straight line from the top corner to where the junction is, but I wanted to check if I'm missing something - it just seems so far off. The cabin wall is at the right angle. I did have to trim the bottom of the cabin wall at each end as the seats are a bit lower in the middle than the sides. That is why the top of the topside sits a bit proud of the top of sidewall.
2. At the bow, the front deck was extending a bit over the sides in places. I trimmed it flush with the sides, but now the topside wants to sit on it. I assume I should trim the deck back a bit so that the topside can sit right on the side?
This is a fun part of the build - it is suddenly taking shape!